![]() If it is a 1.6 motherboard, you shouldn't pull of the clock capacitor, and you're not able to flash the TSOP on it, which means your only choice is to lock the hard drive. If the motherboard version is below 1.6, you should seriously consider doing a TSOP flash as well as pulling off the clock capacitor: If you haven't, then your Xbox is not TSOP flashed. Which version motherboard do you have? Have you soldered a wire on it for TSOP flashing yet? I do know that the dash was Ver.01 and I believe the kernel was Ver.01 when I initially did the TSOP flash. I'm posting this from work, so I cannot provide which MB.Ver I have or any of that as of right now. Could that be because the control board has died? I've tried formatting it and it just tells me that there is an I/O device error. I think the drive shit out on me tbh, no clue how or why but if the drive is unrecoverable I'm ok with it, all my games are backed up elsewhere. Now, I'm not sure if my original drive had a partition or any sort of formatting the first time I did this or not, but one thing I haven't tried is putting some form of partition on the drive.Īlso, interesting tidbit, The old drive reads in HDSentinel as 100%, 1000+ and passes a Short Self Test, registers in Disk Management as being a 1TB drive, but when attached to the Hammer device I have it says that there is 0000GB on the disk. I'm 210% sure I'm hotswapping within the ''5 second timeframe'' you get when the ''FatX'' text appears but it still just won't detect it. I've even tried different 40 and 80-cable IDE cables, including the stock 40-cable that is installed in the XB to begin with. I've made sure the OG Drive is set to Master with Slave Present and that the drive I'm cloning to is set to Slave. It will boot when I do the cable hotswap but it just refuses to recognize the drive. ![]() No partitioning, no formatting, completely fresh drive.ĬHIMP (lpartx) does not like this drive. Freshly zero'd the drive using a CPRTools Hammer device and tried to clone to it. So at this point I'm kinda at my wits end and decide I'd just clone the OG drive with XUnleash on it to another drive I have that tests good in HDSentinel (100%, 1000+ days, passes Short Self Test in 2min target) that also happens to be on the XboxDrives X-Pec site as supported and has EEPROM locking. Used the original drive with XUnleash installed (will boot to no issue, play games from Disk but defeats the purpose of being able to play games off HDD) So I went ahead and rebooted the console as this wasn't the first time it's happened to me and all I've needed to do in the past was reboot it.Īfter rebooting I received consistent Error 07 issues, which from what I understand is bad kernel/can't communicate with drive. Was FTPing some games to it when suddenly it terminated the connection and when trying to reestablish it I received errors stating that the networked drive is unavailable. Cloned the OG drive to a 1TB SATA drive using an IDE to SATA adapter and everything. I followed a YouTube Guide posted by creator P3NCE and everything went rather smoothly and had no hiccups.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |